Open devmgmt.msc (Device Manager) and check for "Finger Vein Module" under the Biometric devices section. Important Notes:
Select and point the installer to your extracted folder. Step 3: Installing on Modern Windows (Windows 10 and 11)
The Ultimate Guide to the Hitachi PC-KCA110 Driver: Installation and Troubleshooting hitachi pc-kca110 driver
: You must run the installer with full administrative privileges . If User Access Control (UAC) is enabled, you will need to confirm the setup permissions.
The server had timed out. He refreshed the page. Nothing. The directory wouldn't load. The mirror was overloaded, or perhaps offline for maintenance. Open devmgmt
The device driver is the indispensable link between this sophisticated biometric hardware and the Windows operating system. Hitachi Global Authentication & Security
The PC-KCA110 defaults to DHCP. Use Hitachi AirNEXT Discovery Tool to scan the local subnet (192.168.1.x or 10.0.0.x). If not found, perform a factory reset: If User Access Control (UAC) is enabled, you
Yes – if the device is already configured and connected via Ethernet to a building management system (BACnet or Modbus), you never need a local driver. The “driver” is only for USB debugging or initial setup.
: Windows may block the driver if it lacks a digital signature. Restart Windows in Advanced Startup Mode and select Disable Driver Signature Enforcement before running the installation. Issue 3: Biometric Software Failure
It is not a simple remote control. Instead, it typically connects via: