Xinje Plc - Usb Driver Install

Set the default baud rate (usually 19200 or 115200 for newer modules) and click or Connection Check .

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

To install the USB driver for a , you typically need to install the from the official Xinje website or ensure it is bundled with your programming software (like XDPPro or XCPPro) . This driver allows your PC to recognize the USB-to-RS232 programming cable used for communication. Step-by-Step Installation Guide Download the Driver : Visit the official Xinje Download Center xinje plc usb driver install

To ensure the driver has been installed successfully:

Look for an "Unknown Device" or a device labeled "Xinje PLC" under "Other devices" or "Ports (COM & LPT)". Right-click the device and select . Set the default baud rate (usually 19200 or

In this guide, we’ll walk through the Xinje PLC USB driver installation process, troubleshooting the "Port not found" error, and getting your hardware online.

Click and navigate to the USB_Driver folder identified in Step 2. Click Next . Windows will install the driver. 4. Verify the Connection If you share with third parties, their policies apply

Click . Windows will scan the folder, locate the .inf file, and install the driver. Step 4: Verify the Connection

. If it says "Connection Successful," you are ready to upload or download code. 💡 Troubleshooting Tips Driver Signature Error:

I can provide specific troubleshooting steps or direct settings for your exact hardware setup. Share public link